Jake.B
New member
OK, i have a 5hp B&S that has about 60 buckks invested in ot for a header some gaskets racing valve springs stainless steel valves and about 6-7 hours of cleaning inside and out. It runs amazing and is a great engine. i have an 8hp B&S that is in the procces of being cleaned inside and out. It needs gaskets an airfilter a carburator that im getting for 15 bucks thanks to Bluewind. It needs a few parts like screws and a throttle plate and seperation gasket they add up about to 14 dollars. Maybe a few other little things. when im done i can garentee it will run great. so basicly a great 5hp and great 8hp. The 5hp is currently on a gocart and it has a clutch and everything to run. the 8hp has nothing gocart wise. Another problem about the 8hp is it has a 1 inch shaft and im not sure if they make cent. clutches that size. so im figuring i have to get a tourque converter.
Should i sell the 8 hp and beef up the 5hp i know its smaller but i like to say im running a B&S engine at 5000 RPM and other mods. The way they are designed too is sorta a problem the 8 horse is alot bigger and heavier because they design by bigger piston and not better parts.
This is the way im heading.
or do i sell the five horse and buy a TC?
Should i sell the 8 hp and beef up the 5hp i know its smaller but i like to say im running a B&S engine at 5000 RPM and other mods. The way they are designed too is sorta a problem the 8 horse is alot bigger and heavier because they design by bigger piston and not better parts.
This is the way im heading.
or do i sell the five horse and buy a TC?