engine build

Status
Not open for further replies.

shanmillerace

New member
Messages
8
Reaction score
0
I just installed a 3 1/2 hp aluminum flywheel on my 5hp briggs and having trouble with the timing it is backfireing throurgh the carb any ideas. This motor is bored thirty over has double valve springs, hot coil,racing cam,billet rod.
 

fowler

New member
Messages
5,463
Reaction score
18
Location
Bullsbrook West Aus
if u pulled the engine right down then make sure u lined the dots up properly on the cam gear

did u do anything else to the engine like rejet, hi flow air filter, remove govner hi flow exhaust

make sure the flywheel key is good

and make sure the magnet on the new flywheel is in the same spot as on the old one
im unsure wether they put it in the same place between models
 
Status
Not open for further replies.
Top