Eletronic clutches. Idea.

Status
Not open for further replies.

robbie

New member
Messages
857
Reaction score
9
Location
Osceola, Missouri
Is that a standard clutch on the jack shaft?

And where do you buy a one way sprocket like that? I have one on the mini bike I just converted from electric to 49cc gas, but I've never seen them offered for sale individually.
 

HellSpawn

New member
Messages
476
Reaction score
2
Location
Wadena, Minnesota
Is that a standard clutch on the jack shaft?

And where do you buy a one way sprocket like that? I have one on the mini bike I just converted from electric to 49cc gas, but I've never seen them offered for sale individually.

I'd assume the weight/spring pack is modified for lower rpm engagement. Considering the jackshaft is spinning considerably slower than the motor.

And you need one-way needle bearings. Should be able to find them at any bearing shop or the like.
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Now where abouts would I be able to find one of them things? I remember seein somebody on OMB forum was makin some, but were over $200... well over my budget.

Or how about making one?
So, after the 1 way bearing, could I use 2 regular clutches, leave one alone, and make the other engage at a higher RPM?
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
Yes, 2 regular clutches, but the one on the js would need to be modified a bit.

This is a basic idea of what I was thinking, READ CAREFULLY few little tips here and there.
 

Attachments

  • 2spd js.jpg
    2spd js.jpg
    92.3 KB · Views: 11
Status
Not open for further replies.
Top