Dropped Valve.? Tecumseh 11hp engine.

Status
Not open for further replies.

rekab69

New member
Messages
4
Reaction score
0
Location
Suffolk UK.
Hi Guys,

Murray go-kart, when trying to start it after standing for a while the pull starter locked solid..

I removed the pull start assembly, the motor turns freely each way only to lock solid..!!

Thinking it's dropped a valve...??

Any other possibilities..??

thanks..

db..
 

thebroketeenager

New member
Messages
95
Reaction score
1
Location
Bakersfield California
As far as a dropped valve, in my opinion that's not the case because usually that happens while the engine is running. Plus, if I recall correctly, there was a thread where some guy dropped his exhaust valve and the engine didn't lock like you described. A few questions before I get to much further.

1. Did the motor sit in the elements?

2. If so, did it have an air filter?

3. Hows your coil-flywheel clearance?

4. Do you have a header on the motor?

I reccomend you take a look underneath your valve cover. Have a look at your valves. I think you have a sticky one. You'll know if you do if the rocker arms move and the valve doesn't when you turn the motor over. Try some penitrating oil and some gentle prying. If your valves are fine, then its either your flywheel hitting your coil(which i think is HIGHLY unlikely) or you have put a rust ring in your bore from water down the engine, which is the worst case scenario.:smiley_omg: Lets hope its not that.:lolgoku:
 
Last edited:

rekab69

New member
Messages
4
Reaction score
0
Location
Suffolk UK.
Hi,

Thanks for your reply, forgot to mention that it turned over a few times before it locked up so probably not a rust ring..

I get time over the coming few days to have a look..

db..
 

rekab69

New member
Messages
4
Reaction score
0
Location
Suffolk UK.
Had a look.. first thing I noticed is I have a 6hp not an 11hp.. D'oh!

it is turning freely now and haven't found out why it was only turning 7/8th of it's rotation in either direction..??!

So back to basic..

Spark yes.
Dry plug so no fuel getting through..
Cleaned out the carb, all clear..

Did a compression test about 25psi...? my gauge is for a car so a bit of a guess as it doesn't read that low to start with..

So no fuel getting through to the engine..

Any ideas..?

thanks.. db.
 
Status
Not open for further replies.
Top