Drive Pulley Question

Status
Not open for further replies.

dweseen

New member
Messages
3
Reaction score
0
I bought this on Craigslist for $75 last week and I can't seem to find a drive pulley that will fit. I took a couple measurements, but I can't seem to find the right drive pulley for this. I am not the most mechanically gifted. I attached a few pictures. I hope to do a lot of fun projects with this.

Tecumseh Motor shaft is 1 inch in diameter.
The belt width was 1.25 inches on the top.
 

Attachments

  • 20160508_204759.jpg
    20160508_204759.jpg
    391.7 KB · Views: 6
  • 20160511_102409.jpg
    20160511_102409.jpg
    215.1 KB · Views: 6
  • 20160508_204812(1).jpg
    20160508_204812(1).jpg
    451.1 KB · Views: 8

ezcome-ezgo

G'me sumthin to write on
Messages
6,028
Reaction score
3,041
Location
Atlanta, GA
Looks like part of a torque converter there. How about a pic of the engine? $70? That's a lot of project for a little cash. Well done.
 

dweseen

New member
Messages
3
Reaction score
0
Here is a pic of the engine
 

Attachments

  • 20160511_171704.jpg
    20160511_171704.jpg
    452.1 KB · Views: 2

dweseen

New member
Messages
3
Reaction score
0
Here is a pic of the other half of the tc, if anybody can help me out. Thanks
 

Attachments

  • 20160511_173725.jpg
    20160511_173725.jpg
    258.3 KB · Views: 4
Status
Not open for further replies.
Top