Drag Bike

[GearHeadGarage]

Someone asked, Can you build a drag bike. Well 9hrs later an issue came up with this. It's wide enough for a Jr. Dragster rear tire. The front is from a 250cc scooter.

 

[GearHeadGarage]

Found a use for the two 212s

 

[landuse]

I will be watching this one

 

[Kartorbust]

So is that GX200 just a placeholder for another Predator? Or is the Predator a placeholder for a GX200?

 

[GearHeadGarage]

So is that GX200 just a placeholder for another Predator? Or is the Predator a placeholder for a GX200?

The other 212 is in the box still. The GX 200 was on the bench, and hasn't been in a photo opp for a wile

 

[GearHeadGarage]

Axle mounts are ready for the plasma table. Still drawing some gussets to beef up the neck and the 2nd engine mount

 

[GearHeadGarage]

Got some work done on the dirt drag bike

 

[GearHeadGarage]

I made the sprockets for the clutches. They were laser cut today. And have two 22mm carbs that'll, I thank look good.

 

[bob58o]

Looks good! Seen your bike in the FB group too!

 

[GearHeadGarage]

Looks good! Seen your bike in the FB group too!

The briggs or 212 group?

 

[bob58o]

The briggs or 212 group?

Must have been the 212 group. I don't own a Briggs. I thought it might have been Mini Bike Nation, but guess not.

 

[GearHeadGarage]

Few things got done yesterday.