ironbutt
New member
No this is not about "The Walking Dead".
I've got a Predator 212cc on a Motovox MBX10.
According to my cellphone GPS speedo app I'm not going above 28mph with the stock configuration (which feels pretty fast btw).
I'm not excited about pulling and opening up the engine to remove the complete governor apparatus. As well, I like the idea of still having the governor available in the future in case I swap or repurpose this motor later.
I was considering just disconnecting the throttle linkages to the governor arm and locking it back somehow if necessary (or could it swing freely?).
But I looked through previous threads here and saw a similar discussion from 2014 in which member Itsid was adamant against that approach...
:Quote
there is such screw..
and I will not tell you where it is
Main reason: you shouldn't!
What you describe as the throttle limiter is in fact a governor,
and it does more than just limit your throttle.
It is a small plastic gear INSIDE the engine that will break if only bypassed.
So in order to disable it, you will have to remove it for the safety of your engine.
look up "governor removal" and you'll see
:End Quote
Is it actually dangerous to leave the governor gear and actuator arm in the engine? It seems like it would just be in the same state as when it is running in lower RPMs.
If I do just disconnect the linkages (and even remove the governor lever) does the arm bolt need to be secured in a certain direction or can it swing freely?
Thanks in advance for your input!

I've got a Predator 212cc on a Motovox MBX10.
According to my cellphone GPS speedo app I'm not going above 28mph with the stock configuration (which feels pretty fast btw).
I'm not excited about pulling and opening up the engine to remove the complete governor apparatus. As well, I like the idea of still having the governor available in the future in case I swap or repurpose this motor later.
I was considering just disconnecting the throttle linkages to the governor arm and locking it back somehow if necessary (or could it swing freely?).
But I looked through previous threads here and saw a similar discussion from 2014 in which member Itsid was adamant against that approach...
:Quote
there is such screw..
and I will not tell you where it is
Main reason: you shouldn't!
What you describe as the throttle limiter is in fact a governor,
and it does more than just limit your throttle.
It is a small plastic gear INSIDE the engine that will break if only bypassed.
So in order to disable it, you will have to remove it for the safety of your engine.
look up "governor removal" and you'll see
:End Quote
Is it actually dangerous to leave the governor gear and actuator arm in the engine? It seems like it would just be in the same state as when it is running in lower RPMs.
If I do just disconnect the linkages (and even remove the governor lever) does the arm bolt need to be secured in a certain direction or can it swing freely?
Thanks in advance for your input!
