Connecting kill switch

Status
Not open for further replies.

Johnnyboy

New member
Messages
72
Reaction score
0
Location
Massachusetts
Hey everyone,
I put a new predator on my Manco Rattler about a month or two ago and have yet to fit the kill switch. It's already mounted to the steering wheel from the previous engine, but where do I connect the loose end?
 

Attachments

  • 1466523987559-69918864.jpg
    1466523987559-69918864.jpg
    136.3 KB · Views: 6
  • 14665240152832105175646.jpg
    14665240152832105175646.jpg
    297.8 KB · Views: 8
  • 1466524044109955495210.jpg
    1466524044109955495210.jpg
    260.4 KB · Views: 6

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,866
Location
Chicago-town USA
https://www.youtube.com/watch?v=0hB0SZj3LAI

---------- Post added at 10:56 AM ---------- Previous post was at 10:52 AM ----------

They yellow wire in your pic goes into the block and goes to a low oil sensor, which likes to shut off go karts when turning.

Most people disconnect the low oil sensor and add the additional kill switch at that connection.

Like the kid in the video said, you'll have two switches. Both need to be on to run. Either will kill it.

---------- Post added at 10:58 AM ---------- Previous post was at 10:56 AM ----------

Disconnect the yellow wire on the Predator thing (at the point under the green thing), then Connect your black and pink thing to the predator's yellow and green thing that goes into that gold box thing. LOL
 
Status
Not open for further replies.
Top