comet tav 30 belt issue

Status
Not open for further replies.

ponyboy

New member
Messages
2
Reaction score
0
Location
michigan
Installed new comet tav 30 on my 71 Gemini b4 scrambler and the center of driver to driven pulley is 8 inches. I can only find belts from 7.625 or 8.188. My question is will the belt be to big if i were to get the 8.188 belt, or modify the motor back .188 of an inch. Thanks you. Matt
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Is there no way you can adjust centre distances? The centres/belts are really quite specific.
I would modify the motor back if you can. 3/16" isn't a lot. Maybe you could extend your engine mounting slots?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Are you at exactly 8" on centre? You may be okay. It's better to have the belt just slightly long than too short. So, go ahead and order the 8.188" belt. Personally, I would adjust the engine location to 8.188 on centre. Moving the engine 3/16" will be very simple.
 

ponyboy

New member
Messages
2
Reaction score
0
Location
michigan
Thank you.

Was able to move motor forward by elongating the holes. Ordered new belt today so hopefully everything works out. This was my first post and would like to say thank you for the quick response. Thanks Matt
 
Status
Not open for further replies.
Top