comet driver

Status
Not open for further replies.

trooper3455

New member
Messages
10
Reaction score
0
Location
Tennessee
Hey guys do any of you know if I can get a comet 40 series driver with a 3/4 in bore. I replaced a 10 hp tecumseh with an 8 hp briggs. the tecumseh had a 1 inch shaft and my briggs has a 3/4 shaft. the driver has a built in key way or else I would get a bushing to make the shaft 1 in. any ideas?
 

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
A bushing sound like your best option without spending buckets of money. The only issue would be your key: You could use a machined 3/8" key, ie: machine a 3/8" key down to 1/4" on one side so it becomes 3/8" x 1/4"
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
There has been a discussion on this before, a member named redsox985 made a bushing to adapt his comet 30 driver (1" bore with 1/4" built-in key) to the 6.5hp clone he was using (3/4" shaft with 3/16" key-way). Use the search feature on the forum, you should be able to find it.

EDIT: Post #26 is what you want,
http://www.diygokarts.com/vb/showthread.php?t=8363&page=2

Basically you take a 1" OD by 3/4" ID section of pipe. Cut a 1/4" wide by 1/8" deep slot on the outside of the pipe, then cut a 3/16" wide by 3/32" deep slot on the inside of the pipe, 180* from the first slot.
 
Status
Not open for further replies.
Top