Comet 30 series bronze bushing on driving backplate?

Status
Not open for further replies.

jamyers

Well-known member
Messages
1,444
Reaction score
49
Location
Buffalo Gap, TX
I picked up this disassembled Comet 30 series. Looks like the PO used liquid lube on it and it gummed up all over, which I'll bet is why it's apart and I got such a deal (yay for me!). Everything cleaned up nicely so far, but... In the box of parts are two driving backplates, one that goes with the rest of the parts and the other is covered in green paint and looks like a spare / extra.

The "good" backplate has no bronze bushing. The "green" backplate has a bronze bushing, but it's pretty solidly stuck on there - I don't think I can get it off without using heat, and it's pretty dinged up anyways (PO trying to remove).

1. Do all Comet 30 series NEED the bushing?
2. If so, how tight is the bushing supposed to be on there? Online videos and other comments indicate it just slips on/off, not a press fit.

I've got to order a belt anyway, so adding a bushing is no big deal, I just want to put it together correctly the first time around.
 

jamyers

Well-known member
Messages
1,444
Reaction score
49
Location
Buffalo Gap, TX
Part #10 in this drawing, it goes onto the backplate #12

 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
The bushing is an Idler bushing. It is necessary for proper operation. You should be able to find it from nearly any dealer for cheaper than 10 dollars. I've seen some bushings HORRIBLY stuck on driver backing plates before, always able to get them off. You may need to pry it one direction or the other, apply heat, or even destroy the bushing I if comes down to that action.
 
Status
Not open for further replies.
Top