Clutch Removal

Status
Not open for further replies.

J42NA

New member
Messages
2
Reaction score
0
I am swapping out an old Subaru Robin 5hp engine for a new one and cannot figure out how to get the hub & sleeve off the old engine shaft. (#12 in pic) It doesn't appear to be held on by rings or screws.

I ordered a new Max Torque clutch for the new engine but wasn't sure what parts it will include. Do the new clutches typically come with the hub & sleeves as well?

Many thanks in advance.

Great site.

J
 

Attachments

  • Stand.gif
    Stand.gif
    24.2 KB · Views: 28

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
Unless you still have a bolt/washer at the end of your crank holding it on, or theres a set screw in your hub & sleeve you havent found yet, Its probably just rusted on and you could try soaking the area with some penetrating oil. If that doesn't help you might have to resort to a 2 or 3 jaw type puller tool to remove it.

To avoid this problem next time, lots of guys put some "Never Seize" (from auto parts store) on the shaft before installing the clutch.

New Clutches usualy come complete with everything.
 
Status
Not open for further replies.
Top