Clutch removal

Status
Not open for further replies.

leesiel

Yardcart 196
Messages
223
Reaction score
1
Location
Savannah G.A.
Trying to remove governor and don't want to pull cam.How do I get this off? Do I need to pull this off?. Trying to finish today so kids can ride at bday party.
 

Attachments

  • 20151205_125343.jpg
    20151205_125343.jpg
    155.8 KB · Views: 8
  • 20151205_125330.jpg
    20151205_125330.jpg
    166.7 KB · Views: 8
  • 20151205_125337.jpg
    20151205_125337.jpg
    157.3 KB · Views: 6

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
No Offense but is there any set screws or is that thing just stuck. If so try pb blaster or a good penetrating oil. It should come off eventually but it does suck cause you dont want to beat or pry too hard and screw up the crank. :(
 

Zombient

Junkyard Derelict
Messages
565
Reaction score
7
Location
Waco, Texas
http://www.harborfreight.com/automotive-motorcycle/pullers/three-jaw-puller-set-3-pc-69105.html

 

Poboy kartman

Senior Moments Member
Messages
12,461
Reaction score
73
Location
White Settlement Texas
First off....yeah..it's gotta come off....Secondly, it's GOT to come off....(it's not part of the crank, and likely only held on by rust).....

Follow the above ^...
 

DHC

New member
Messages
111
Reaction score
4
PB Blaster (not WD-40!) Soak it... after loosening locking bolt (if present).

If that don't work.. n if in a hurry... u can try propane torch it n tap on it... usually works for me (knock on wood).

This is just if u don't have access to a pulley puller.
 

leesiel

Yardcart 196
Messages
223
Reaction score
1
Location
Savannah G.A.
PB Blaster (not WD-40!) Soak it... after loosening locking bolt (if present).

If that don't work.. n if in a hurry... u can try propane torch it n tap on it... usually works for me (knock on wood).

This is just if u don't have access to a pulley puller.

Heated it and tapped it off fairly easily . Once i was done put it altogether went to ride and broke my new chain cause I forgot to tighten motor down tight.que sara sara:censored::censored::censored::mad2:
 
Status
Not open for further replies.
Top