Clutch help

[Mike10gs]

Hi guys i am new to go karts and need help finding parts.
Clutch broke off and need help how to out one on and how to fund the right one. I bought one but not sure if it fits correctly. I have predator 212. Here are pics

 

[bob58o]

Take the rest of the old clutch off.
Then if the shoe fits you can lace that b up and wear it all over town.

Somebody will jump in and tell you how to oil the clutch so the new one doesn't meet the same fate.

 

[mckutzy]

It was wore the frick out for sure...

The hub needs to come off of the shaft...
Clean the end up with a fine scotchbrite pad by hand... You'll need a puller... Some heat from a torch...
Heat the hub and keep it moving.. Don't cook the shaft seal..

It'll come off quick...

Don't use the torch if you aren't comfortable with fire around the gas tank...

The long and short of it...

 

[Mike10gs]

Thank you guys so much. I did not think it fit but it does. Just like you guys said have to take the old out. Yea it sat for a while and just popped off when riding it after who knows how long it sat.

---------- Post added at 10:44 AM ---------- Previous post was at 10:22 AM ----------

So actually the clutch I bought does not have the little screws on back to tighten

 

[mckutzy]

It doesn't really matter... As long as there is a key in the hub to engage with the crank shaft..

 

[Mike10gs]

I'm not to good with the ratio was hoping someone will tell me if this ratio works ok. My chain seems to either be a bit loose or a bit too tight. This is for my uncles go kart that I am trying to help him figure this out.

Has 17" tires, sprocket is 13" , has 100t sprocket and have a 12t clutch

 

[mckutzy]

Shim the engine up a bit with some washers when bolting it back up.