Clutch help

Status
Not open for further replies.

Propdoc

New member
Messages
2
Reaction score
0
I need help figuring out and/or finding a clutch for a go kart project I am starting. I have a rolling chasis that has a 1" rear axle with a 1/4" keyway. The engine is a 9hp and has a 1" shaft also with a 1/4" keyway. I want the go kart to have good power and speed as well as be suitable for on and off-road use. I have looked everywhere for a torque converter style clutch with no luck. It seems they don't make one with for 1" engine shaft and 1" axle. Any suggestions/advice will be great.
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Perhaps you are getting confused by the fact that the driven unit tends to be 5/8" or 3/4". That driver is NOT intended to go directly on the axleshaft. It is to be mounted on a jackshaft, with a sprocket driving your rear axle via chain.
 

Propdoc

New member
Messages
2
Reaction score
0
I did not know that the second pulley wasn't mounted directly to the axle. So if that's the case, and I obviously don't have a jackshaft, I can get any size second pulley diameter since I have to also find a jackshaft. What are the best sized sprockets and/or number of teeth to get for the best combination of power and speed?
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
That torque converter system I linked comes complete with "drive and driven clutches, belt, engine mounting plate with a built in jackshaft and sprocket, all hardware, and installation instructions".

The rear driven pulley and jackshaft all bolts a mounting plate, and then that plate bolts to those 4 threaded holes on the side of your engine:



So you'd just need to have an axle sprocket and chain to install it.

__________________________

To recommend your gear ratio we need to know:

How many inches tall your karts rear tires are?
And how many teeth are on the axle sprocket on your kart right now?

And also measure and post the distance between the teeth on your current axle sprocket, just so we'll know if you have a #35 or #40/41 sized chain and sprocket now.
 
Status
Not open for further replies.
Top