Clutch doesnt have set screw????

Status
Not open for further replies.

jeckel7234

New member
Messages
25
Reaction score
0
Ive got a centrifugal clutch im trying to put on my hf 212cc motor, the clutch doesnt have set screws or any other type of screw or hole that would look like it mounts to the shaft? So how do i mount it thanks
 

jeckel7234

New member
Messages
25
Reaction score
0
By using a bolt in the end of your engine's PTO shaft (and a washer).

yea sorry i did put that in the original post i tried that, the part of the clutch with the teeth for the chain stays put for the most part but the part of the clutch that expands out slides all the way toward the engine leaving about 1/4" that would contact the walls of the other piece. Is a centrfiugal clutch supposed to be held together by something? or when i throttle up will it force the pieces closer?
 

jeckel7234

New member
Messages
25
Reaction score
0
I dont see anywhere that looks like a snap ring would go heres some pictures front and back of both pies and down the shaft hole


 

Attachments

  • IMG_20120707_134549.jpg
    IMG_20120707_134549.jpg
    111.8 KB · Views: 4
  • IMG_20120707_134601.jpg
    IMG_20120707_134601.jpg
    87.2 KB · Views: 9
  • IMG_20120707_134609.jpg
    IMG_20120707_134609.jpg
    77.7 KB · Views: 7
  • IMG_20120707_134618.jpg
    IMG_20120707_134618.jpg
    72.8 KB · Views: 4
  • IMG_20120707_134625.jpg
    IMG_20120707_134625.jpg
    86.8 KB · Views: 4
  • IMG_20120707_134636.jpg
    IMG_20120707_134636.jpg
    98.9 KB · Views: 4
  • IMG_20120707_134647.jpg
    IMG_20120707_134647.jpg
    87.4 KB · Views: 4
  • IMG_20120707_134657.jpg
    IMG_20120707_134657.jpg
    131.3 KB · Views: 5

jeckel7234

New member
Messages
25
Reaction score
0
and in the second picture the crack, is that going to cause any big problem it doesnt seem to of made anything loose
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
That crack, and the others, indicate that the bushing is about to self-destruct.

If there's absolutely nothing there to hold the clutch together, install a locking collar on your PTO shaft right behind the clutch to hold it from sliding toward the engine.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Nodroz, the PTO shaft stands for Power Take Off shaft. In other words, crank shaft!

I would replace that bushing, here is one that should fit.
Sorry, never owned one of these, so cannot help with the other issue.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
May be the easy option since yours already requires over $10 in parts. You can get a new one for around $40 or a cheap maxtorque for $25
 
Status
Not open for further replies.
Top