Clutch burning out?

Status
Not open for further replies.

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
I have a 4.6 Ratio with a 5 horse Briggs and stratton i weigh about 125 and the frame around 50-60 not including the motor is that a good enough ratio?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Not enough info. Need rear tire diameter, at the very least. Pics of kart would help too, to get a "feel" for it. Odds are, 4.6:1 isn't deep enough.
 

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
I believe it is 12.5 rear tires but something makes me think it is 8.5 i just bought the clutch and i don't want to burn it out i rather spend money on a new sprocket than buy another clutch. I don't have any current photos of the cart its still in construction i can post some but there before i started.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
And remember- you need to measure overall diameter. Measure right from the ground straight up to the very top of the tire tread. Most accurate measurement is actualy static loaded radius x2. (Which is measured from the ground to dead centre of the wheel hub, multiplied by 2, WITH the tires at correct pressure and driver's weight in the kart).
 

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
OK it is 12 inches i don't have it at my house sorry it to so long to get back to you guys.

I have ten inch tires available
 
Status
Not open for further replies.
Top