Clone gov.

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
If I bypass/remove the governor do I just need stiffer valve springs? Or must I hav a billet connector rod and billet flywheel? This engine would be run most everyday and would be ran really hard , would it be safe ?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
IMO, you're actually safer to leave the factory stock valve springs in so that they will act as a natural rev limiter.

If you change them for stiffer springs, now you're into a hi-po rod/flywheel. $$$
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
so your saying that its safer to leave those in because if i go to high the valves will float, but if i change them it wont stop it and i could blow a connecting rod?
 
Status
Not open for further replies.
Top