Clone cutting out

Status
Not open for further replies.

birddog1148

New member
Messages
112
Reaction score
3
Location
Sandusky, oh
Ok, on the kart the clone motor keeps cutting out. Changed the carb yesterday and it ran great in practice. Took the cart out in the heats and feature and kept cutting out. Get back in the pits and it would start again. Alreadey spaced the fuel pump off the plate. How do I check the coil? It only does this when its warmed up, not when its cold.:mad2::huh:
 

birddog1148

New member
Messages
112
Reaction score
3
Location
Sandusky, oh
i assume you already removed the oil sensor?

Was running the kart the way I bought it and supposedly it was done, I never checked. Is the oil sensor the fitting in the block or the little block above it? I have a brand new blue HF engine I got last year when they were on sale and never used. it has a little box and a wire that comes out of it. And there is the plug that comes out of the block. The lille box is not on the cart but the plug in the block is and hooked to the kill switch wires.
 

birddog1148

New member
Messages
112
Reaction score
3
Location
Sandusky, oh
What is this?

It is not on the kart.

This is how the kart is, ran fine first few times I raced it. Just changed oil yesterday 16 oz thor red.



Stock out of box clone
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I don't have the spec in front of me right now, but 0.010" is always a safe number. Whenever I'm tinkering on an engine that I don't have the data for, I set to that gap. Never failed me yet.
 

oldbikerarlo

Old guy
Messages
449
Reaction score
2
Location
Marana, Az.
I think your problem is the bare connector hitting the block. In the 2nd picture. Don't know for sure but I think the little box is a relay that shuts the engine off till the flywheel quits producing a charge and then resets itself.
With that removed and the bare connection hitting the block it would be like clicking your kill switch on and off.
Then it could be, That the oil senser is turning on and off. try cuttin the wire make sure you put some tape on the ends.
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
Yellow wire just needs to be disconnected, no cutting. Wire from block (sensor) can hang free as there is no power emanating from it or going to it. Does not need taping or any other insulation.
 
Status
Not open for further replies.
Top