cleaning carbon deposits

Status
Not open for further replies.

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
ok so its not a small engine but its an engine none the less. its from a 1987 jeep Cherokee it has alot of carbon on cylinder heads and throttle body. would it be ok to dip the alumin part in boiling water to help loosen it up? i have spray for it but i only have a small can. would it be ok to dip them in hot water? if so what temp would be the max as to not warp them?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I don't know how effective hot water will be, but it's a fair bet that you won't get it hot enough to "hurt" engine parts. Think about combustion temps.
 

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
yea i know but i read somewhere that not to get it above 350 when baking the parts in an oven to help remove them.not sure if its true or not. but water boiling point is only 212F so im good on that point
 

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
computer engine? talking about the engines that rely more on the ecm and other electrical parts then the engine its self?
 

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
so boiling the parts in water wont hurt them. but would it help loosen the stuff up?
 
Status
Not open for further replies.
Top