Have a Baja MB165 with the Predator motor & TAV30 in place. Here's my question. I bought one of the cheap Chinese tachs (one button adjust, tach, hour meter, etc.) & put it on the hemi predator today. I set it up with the "correct" code for a 4 stroke motor (1P2r, one spark per 2 revolutions) & got about a 4000 rpm idle reading like that. Hmmm?
Screwed around with it at different settings & finally settled on the code for a 2 stroke motor (iP1r, 1 spark per one revolution) which gives me about 1900 rpm at idle, which actually seems close to right, as it's a factory motor with no mods done. Still need to ride it some to see full rpm's, but has anyone else run into this problem with this POS tach?
Second question, I haven't messed with the governor at all but I did unscrew the stop/adjustment screw holding the butterfly at about 1/2 open from the factory. Pulls a lot better now & winds up tighter, or so it seems. Are there any issues with doing this if the governor hasn't been touched & all springs, linkage & stuff is still intact? Runs a lot stronger & I have yet to feel the governor work at all on this motor, but I don't have a really long straight to let it wind fully.
I need to get clocked to see what type of top end I have now with the TAV & factory rear sprocket. Should be about 40, I guess, but it's a lot different with the new motor & TAV. Thanks, tim
Screwed around with it at different settings & finally settled on the code for a 2 stroke motor (iP1r, 1 spark per one revolution) which gives me about 1900 rpm at idle, which actually seems close to right, as it's a factory motor with no mods done. Still need to ride it some to see full rpm's, but has anyone else run into this problem with this POS tach?
Second question, I haven't messed with the governor at all but I did unscrew the stop/adjustment screw holding the butterfly at about 1/2 open from the factory. Pulls a lot better now & winds up tighter, or so it seems. Are there any issues with doing this if the governor hasn't been touched & all springs, linkage & stuff is still intact? Runs a lot stronger & I have yet to feel the governor work at all on this motor, but I don't have a really long straight to let it wind fully.
I need to get clocked to see what type of top end I have now with the TAV & factory rear sprocket. Should be about 40, I guess, but it's a lot different with the new motor & TAV. Thanks, tim