centrifugal clutch help

Status
Not open for further replies.

pblr89

New member
Messages
17
Reaction score
0
i have purchased a 2 seater gokart with everything but an engine. i bought a 212cc harbor freight predator engine. now im looking for a clutch to put on it and it should be ready to run. my problem is idk what size and what fits. i have taken measurements the tires are all 13inches diameter, the sprocket is 12inches with 72 teeth. i would prefer 40mph or greater without sluggish acceleration. if someone could help me figure this out id appreciate it. thanks
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
If your axle sprocket is a #35, you should get a 12T clutch setup. the predator is probably a 3/4" shaft so your nearest Tractor Supply would have them, idk about a lowes or homedepot.
 

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
Your not going to pull off 40mph with a stock motor and your cart setup. 2 seaters equal weight, 12:72 is a 6:1 ratio. Is a perfect gearing. To achive that speed you will need a larger engine, modify your current, or maybe a TC.
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
Your not going to pull off 40mph with a stock motor and your cart setup. 2 seaters equal weight, 12:72 is a 6:1 ratio. Is a perfect gearing. To achive that speed you will need a larger engine, modify your current, or maybe a TC.

Another thing he could do is increase the rear tire size.

I'd throw on some 15x6-6 on the rear and put the 13's on the front. You can increase speed by a lot from increasing the tire size, but you have to remember that the gear ratio needs to be set right for the tire size. In this case, increasing to the 15's wouldn't make a large difference, you'd still be able to use your gear ratio and it'll be fine.
 

cumminsbayou4x4

New member
Messages
829
Reaction score
3
Location
fairhope alabama
i have a 2 seater gocart witha 212cc preator it gos 40 with a 60 tooth sproctet if it has number 35 chain go get a number 41 sprocket cause the number 35s suck they sling chains and the cluches at tractor supply are good but the number 35 ones break
 
Status
Not open for further replies.
Top