CB400 Buggy

Status
Not open for further replies.

Mrrcarney

New member
Messages
43
Reaction score
0
oki guys I am thinking of buying this engine off a forum member

I have a few questions

this is my rear swing arm/frame It needs modified or replaced its not long enough and not strong enough.



this is the mounting points for my swing arm



This is My Plans

Build a New swing arm out of 50x50x2 (2"x2"x3/4)
Ebay Clicky Box Section
I have access to this anyway so cant beat free

My questions are

1. Is this steel suitable ?
2. would the mounts on the kart frame hold the stress ?
3. am I better off removing the rear suspension ?

thinking about this


this is just more to add strength than anything else would this design be strong enough for the CB400N 26.7 hp @ 7500 rpm and 24.5 ft·lbf @ 8000 rpm

I will also consider 1.5"x1.5" square tube or even round pipe if some one can tell me how I can notch the pipe for welding

this is on a budget so wont buy a notcher

any advice will be taken with thanks as I am a light/heavy mechanic I know nothing about karts or bike engines but i am a fast learner

kind regards
thanks in advance
Robert

EDIT:: SORRY FOR LARGE PICTURES AND CRAP MS PAINT DESIGN
EDIT 2 :: POWER FIGURES OF 52HP I HAD FOUND WERE OFF A 4 POT MOTOR THIS ONE IS THE MUCH SMALLER 2 POT MOTOR

I THINK I MAY GET AWAY WITH JUST EDITING THE CURRENT SWING ARM FOR NOW AND ADDING SOME SUPPORT

ANY ADVICE
 

Attachments

  • new frame idea.jpg
    new frame idea.jpg
    116.9 KB · Views: 53
Last edited:

fowler

New member
Messages
5,463
Reaction score
18
Location
Bullsbrook West Aus
u will need to completely redo the hole frame (ask u guessed)

if u say u are a mechanic u should be right with bike engines as they are just standard petrol engines with brand speific parts

the metal u have is a massive overkill and it should really be round (stronger and looks better)

id go 30mm dia by 2mm wall
u dont need a tube notcher but it is easyer

u can notch with a grinder

if i was u id try and sell that running kart for a frame a little more up to it
 

Mrrcarney

New member
Messages
43
Reaction score
0
u will need to completely redo the hole frame (ask u guessed)

if u say u are a mechanic u should be right with bike engines as they are just standard petrol engines with brand speific parts

the metal u have is a massive overkill and it should really be round (stronger and looks better)

id go 30mm dia by 2mm wall
u dont need a tube notcher but it is easyer

u can notch with a grinder

if i was u id try and sell that running kart for a frame a little more up to it

this frame is not worth alot and its crap with the low power wont move on a small grassy slope

the main body is made from 25mm dia by 2-3mm wall tube i would want to keep the seat,harness,steering rack ect off of this kart but for anything better i would be talking £700+ that's nearly $1300 and as i said "budget kart"

and I am a diesel mechanic
 
Status
Not open for further replies.
Top