Carb Cleanout

Status
Not open for further replies.

Jimbo86

New member
Messages
102
Reaction score
0
Location
Northern Virginia
Hi,
I'm a prowler around here on the forums and was wondering if anyone could give me a quick tutorial on how to clean a carb. I have a 4hp Subaru Robin and it won't start. (don't worry it has gas) Thanks in Advance!
 

qtband

Well-known member
Messages
1,766
Reaction score
61
Location
St. Louis, MO
Most carbs are the same. I found some good videos on Youtube. I'd go there and check them out. Good luck!
 

jamilcobra

New member
Messages
22
Reaction score
0
Location
Manning, South Carolina
The carb is pretty simple to clean. If fuel with ethanol sits in the carb for a while without being run it will leave a residue that normally clogs up the emulsion tube. If you take the carb off, remove the bolt that holds the bowl on, then unscrew the jet from the center post that hangs down the emulsion tube should slide out. Some are screwed in, but you will see it. There are 6 or 8 tiny holes that I use a small wire to unclog.
 
Status
Not open for further replies.
Top