DirtTrackRacer_07
DeeR SlayeR
I am looking for a camshaft for my Briggs and Stratton 18 hp, opposed twin, vertical shaft engine.
I have deburred the intake and exhaust chambers, built a homemade intake manifold, put a 36mm mikuni square slide carbuertor on it, and put straight pipe daulled exhaust on it.
I am wanting a good low end cam or middle range, basically anything better than stock.
I have searched the site and some other place, but i can not find many performance parts on this motor.
I have ground my own cam before in a 3 hp Briggs but i would rather buy one for this motor.
Any help on naming some manufactors or any information would be greatly appriatted.
I have deburred the intake and exhaust chambers, built a homemade intake manifold, put a 36mm mikuni square slide carbuertor on it, and put straight pipe daulled exhaust on it.
I am wanting a good low end cam or middle range, basically anything better than stock.
I have searched the site and some other place, but i can not find many performance parts on this motor.
I have ground my own cam before in a 3 hp Briggs but i would rather buy one for this motor.
Any help on naming some manufactors or any information would be greatly appriatted.
