Building a Victa powered 2-Up Go Kart

[rameses32]

Parts finally showed up, so started working on the Go-Kart again. The rear sprocket is as big as the tyre so I will be upsizing the rear tyres. Made the seats and covered them, made the drive Hub, I'll be making new hubs for all four corners as well. Also made another frame to go below the original as I made it from too thin of steel, oh well, lesson learned, not a big problem at all. Also attached the floor pan. Gonna paint it tomorrow and use it as a billy cart cause the grandkids are up for Easter, took them down the hill with out brakes at about 20 mph and they loved it.
CHarley

 

[dragracing1213]

That looks like a good project...I like the design. I hope the grandkids have fun...

 

[EagleTalons]

Wow, that is a nice clean project!

 

[r_chez_08]

omg! could you work any faster?! should be sweet when finished!

 

[Kaptain Krunch]

I like it, are you planning on some beefier tires? those seem like they might not hold up too well.

 

[timmytim]

Hey nice kart and nice welds too. Good work my man!!

 

[brendonv]

Did u finish this thing? I wanted to see how it would go with the victa and what carb u put on it and how u mounted it.