Briggs & Stratton 2hp

Status
Not open for further replies.

Nodroz

New member
Messages
1,071
Reaction score
10
Location
Belgium (Europe)
Hello guys,

Yes, this is my first post on this forums! ;)

I've an ATCO 4 stroke engine, the commodore. The problem was that the coupling + the engine wasn't powerfull enough to pull my gokart. I needed to make speed with my pedals, before I could start off. Therefore, I'm now looking for another engine.

I've seen that Briggs and Stratton is one of the best engines out there, so I've been searching the net for those engines.

My budget isn't that much. It's about 100 euro max, for the engine. I've seen an 2hp engine, but I fear if 2hp will be enough to pull my gokart.

So, my question is: Can a 2hp engine pull my gokart up from standstill to 30/35km/h?

If not, would 5hp do enough then?

Regards,
Nodroz (From Belgium)
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Go for the 5hp. Yes, if geared proper the 2hp could get you there... however it might take a while... get a 5hp, more power, more fun! :D
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Bonjour!
Je ne sais pas si tu parle francais, mais je veux espere!
Je ne choisisez pas le moteur deux chaveau poweur.
I do not know if that made any sense :L
I would go for a 5hp motor or above. Make sure it has a 5/8 or 3/4" straight shaft with a keyway.
Have you got any pics of the kart?
I tried doing some searching online, but could not find much.
Briggs and stratton, Honda, techumseh and more are all good motors.
€100 =~ $100us for the American folk!
You may want to look around for old rotovators, really old horizontal shaft lawnmowers and other power equipment. Generators usually have a tapered shaft, so require modification or replacement of the crankshaft which is usually €30 up.
 

Nodroz

New member
Messages
1,071
Reaction score
10
Location
Belgium (Europe)
Thanks for the replies!

I understand a little bit of France, but don't ask me to write this in French.

I've found something on ebay, http://www.benl.ebay.be/itm/270890798881?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
The only problem is that is doesn't have a clutch, so I'll need to buy one.

Also here, a old engine, 8hp. The only problem is that I can't see any clutch on it, so I'll need to buy one too. http://www.2dehands.be/tuin/gereeds...52.html?qq=motor&list_cat=grasmaaier&afd=tuin

This engine had unknown hp. I contacted the seller to know it. The engine looks good + it has a clutch.
http://www.2dehands.be/tuin/gereeds...r-112719174.html?list_cat=grasmaaier&start=82

I think these are some of the engines that should be good for my project.
Still looking!

Regards,
Nodroz
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
I would personally go for the top one. It is a clone of a Honda gx200. The only problem is you would need a 20mm clutch or to file down the shaft. The middle one has no recoil and the pulleys may be rusted on, and the bottom one looks low HP.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
I also agree about the top one. Also, you will very rarely buy an engine that has a useable clutch for a kart on it, unless it came of a go kart in the first place
 

Nodroz

New member
Messages
1,071
Reaction score
10
Location
Belgium (Europe)
Hmm, the problem is that my budget is only 100 euro. The top engine is already about 105 euro including the sending costs.
I don't know the price of a clutch, nor I have any idea where I can buy good clutches. Do you guys have some links / types of clutches?

Thanks for the replies!

UPDATE: I've just found this one. http://www.benl.ebay.be/itm/330681450310?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649
Pretty cheap so far, but it could rise the coming day. It has quite a lot of power. (8hp). If the bidding doesn't go over 50 euro, I could afford me a decent Clutch.
He dude also says the engine doesn't start. I think with a bit of cleaning and a new spart, it should run again.
 
Status
Not open for further replies.
Top