Briggs Service Manual

Status
Not open for further replies.

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Hey folks-

I had a co-worker give me an ancient monster of a snowblower in a non-running state. I've been tinkering with it, but I really could use a service manual for the proper specs. The engine's MTC is 190402 0987-91 77052511, it's an 8hp horizontal flatty.

If anyone's got the service manual in electronic form, I'd sure appreciate it. I've had no luck yet finding one online (free). I'll pay for one if I have to, I'd just rather not... ;)

So far, I'm doing it by "feel". Coil air gap at 0.020", points at 0.020", plug at 0.030", etc...

Cheers!
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Thanks for the effort, fellas, but so far no good. Kendel's link was barb stuff, and Devino, that's where I got the operator's manual- but no service manuals... Anybody else?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Well, well! It LIVES!!! Got the old beast running. Turns out the coil was done. By sheer luck, and my inherent aversion to throwing things out, I had the right coil! I tore down an old riding lawnmower years ago when I started the kids' kart project. As the engine was a vertical, I set it aside and forgot about it. When I suspected the coil to be bad in this snowblower, I went looking for the engine. I haven't even seen it in three years, and sho' 'nuff, an 8hp Briggs from about the same era! What luck!

At any rate the snowblower now runs, but only on choke... I REALLY could use a service manual for the carb!!! I'm going to start ripping into it shortly, but I have no specs...

BTW, I'm gonna put up pics in a bit to see if anybody can ID the snowblower.

EDIT- If nobody's got the engine service manual, how about one for the Briggs updraft carbs- I did get the engine running, but on almost full choke only- this carb needs HELP!

Another semi-random thought. Since I'm not familiar with these engines and have no manual- It took me a few minutes to figure out how to get the recoil clutch off. At first, I didn't realize that the recoil clutch also serves as the flywheel nut. Since gentle prying didn't do it, I figured it might turn off. Impossible to grab with conventional wrenches! Here's how I did it- How are you supposed to do it???
 

Attachments

  • IMG00128-20110227-1453.jpg
    IMG00128-20110227-1453.jpg
    122.5 KB · Views: 7
Last edited:

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Minor update- Tore the carb apart last night, cleaned it all up, reassembled (old gasket) and put back on engine tonight. Started okay, idled off choke, but stumbles and stalled on acceleration. Again- Manual??? Ohpleaseohpleaseohpleaseohplease?????

I know... patience...
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I think I will. I always try for free first. But I will if I have that fails. I truly believe the most valuable tool you can have is the appropriate service manual.
 
Status
Not open for further replies.
Top