briggs and stratton help id ???

[kidn1980]

I'm new to go karts and got my son one with a bs motor but does not say what hp I assume it's a 5 but info on it as follows:

Model:136212
Type:0026 01
Code:960925ya

Also looking as to what mods and any info so please put your links and very much appreciated [/ATTACH]

 

[rushking19]

Ok it's a 206cc 5hp,and they have lots of mods for that motor

 

[kidn1980]

Rushing : thanks for replying where could I find mods

Also it is installed on go kart however when go kart cones to stop at stop sign it turns off why?

 

[rushking19]

It depends what type of mods are you talking about mild mods like intake and exhaust, or major mods like race parts ,and is your carburetor clean?

 

[Zombient]

http://www.bmikarts.com/Briggs-Engines-Parts_c_15.html

https://www.ombwarehouse.com/Performance-Engine-Parts/Briggs-5HP-Flathead

There ya go.

 

[Poboy kartman]

Also it is installed on go kart however when go kart cones to stop at stop sign it turns off why?

Because it feels guilty for driving on a public road?

Is it being killed by the clutch not disengaging? What does it idle like warm and cold....it's really hard to say...could be too high an idle or too low or even a partially clogged idle circuit....

A video would be most helpful, but a little more information may get us there....

Welcome to the forum.

 

[Ean Gdaniec]

I had the same exact problem with the engine dying after coming to a stop. Once I cleaned all ports in the carburetor with carb cleaner I worked perfectly. I assume it is because letting off the gas when clogged will have the engine without enough force the eject the gas through the clogged region.

 

[Poboy kartman]

I had the same exact problem with the engine dying after coming to a stop. Once I cleaned all ports in the carburetor with carb cleaner I worked perfectly. I assume it is because letting off the gas when clogged will have the engine without enough force the eject the gas through the clogged region.

Yeah....to clarify, the carb is drawing in fuel basically by the action of suction....and above throttle...the velocity and volume of air is creating enough suction to draw enough fuel through the clogged passages.....

To make an anology....if you squeeze a soda straw nearly shut....you may be able to suck hard enough to still get a pretty good drink, however, with the same amount of force that would normally give you a good sip, may not get there....

But, there are other possibilities.....

 

[kidn1980]

Ok sorry have not had time to respond but cleaned carb worked like champ son drove it them quit on him now pull start won't even go clank clank on every pull as I saw him roll up to house it was smoking so I can only assume it overheated and locked up

 

[kidn1980]

Will the clutch off the 5hp work on 8hp or 6.5hp

 

[Ean Gdaniec]

Sounds like you were having the same problem as me. It worked like a champ, but then when I got back on, I would even clank. So what I recommend is take out the dish underneath the carb (that holds the gas) very carefully and efficiently, and clean both small holes. I had no problems afterward once I did this.

 

[Poboy kartman]

Sounds like you were having the same problem as me. It worked like a champ, but then when I got back on, I would even clank. So what I recommend is take out the dish underneath the carb (that holds the gas) very carefully and efficiently, and clean both small holes. I had no problems afterward once I did this.

Did you miss post #9?

 

[Ean Gdaniec]

Hmm, I had that problem before, but I do not remember what I traced it to... Did you clean the exhaust?