Briggs and Stratton 5 HP

Status
Not open for further replies.

basifus

New member
Messages
3
Reaction score
0
Hi everyone,
First, sorry for my english because i'm french.
So i have a briggs and stratton 5hp i/c (135292-1194-E4) on my homemade kart and i want to replace the dimmer or the clutch i don't know what it is.
How can i remove it ?
Where can i find an other one ?
Is it a clutch or a dimmer ?

Thanks for your help :) :auto:
 

Attachments

  • Photo 25-02-12 18 58 19.jpg
    Photo 25-02-12 18 58 19.jpg
    242.5 KB · Views: 7
  • Photo 25-02-12 18 59 04.jpg
    Photo 25-02-12 18 59 04.jpg
    249.8 KB · Views: 8
  • Photo 17-04-12 15 15 02.jpg
    Photo 17-04-12 15 15 02.jpg
    245.4 KB · Views: 9
  • Photo 17-04-12 15 15 12.jpg
    Photo 17-04-12 15 15 12.jpg
    236.9 KB · Views: 7
  • Photo 17-04-12 15 15 17.jpg
    Photo 17-04-12 15 15 17.jpg
    197.8 KB · Views: 6

Jake.B

New member
Messages
495
Reaction score
0
Location
California-USA
Im not sure what a "Dimmer" is, but when you start your cart does it just take off or do you have to give it some throttle first? If you do you have a Centrifical Clutch. It dosent look like one but i cant be posotive. You have an oddball shaft though. It has that hex shape to it. I have never seen a Inner bore that shape.

Let some of the more experianced member comment. Alot of them are very smart and know what they are talking about.
 

basifus

New member
Messages
3
Reaction score
0
In fact, this shaft in on an other "normal" shaft. The question is how can i remove it to put an Centrifugal Clutch ?
 

jamyers

Well-known member
Messages
1,444
Reaction score
49
Location
Buffalo Gap, TX
Looks like you've got a set-screw in that inner pulley flange, have you loosened it?

If the inside of that hexagonal shaft is threaded, you might get a puller to grab it there instead of the outside diameter of the pulley. Of it could be like a shredder/chipper I've seen where the impeller (in your case the hex shaft) is threaded and you run a bolt down in there and it pushes on the end of the crankshaft and removes the part.
 

basifus

New member
Messages
3
Reaction score
0
I tried to run a bolt in the inside of the shaft but the part don't move.
Have you an other solution ?

Thanks a lot
 

jamyers

Well-known member
Messages
1,444
Reaction score
49
Location
Buffalo Gap, TX
If you've made SURE all set screws, locks, etc are loose / removed, then I'd suggest soaking it in penetrating oil every time you walk by it for a couple of days, along with hitting it sharply with a hammer to try and jar it loose enough for the oil to penetrate. Then use a pulley/gear/wheel puller, along with more oil and hammer-shocks, and if that doesn't get it then I'd use a propane or acetylene torch to heat it, followed by more oil to the insides (trying to heat the outside and cool the inside), then more puller action.

If you're not trying to save the pulley, you don't have to worry about tearing it up.
 
Status
Not open for further replies.
Top