Bk200 carburetor problem
- Thread starter David mc
- Start date
Denny
Canned Monster
That looks like the seat for the needle. If so that’s not good.
A new one comes with the rebuild kit. But I just don’t know where it goes? Apparently it doesn’t fit tight because it just fell out when I took the carburetor apart. I just didn’t see where it came from.
Denny
Canned Monster
Got a picture of the underside of your carb? The seat does need to fit tight to work properly.
I’ll have to send it tomorrow. I’ve already put it back together and I’ll have to pull it off again. Thanks for your time.
Rat
Well-known member
Definitely the float needle seat.
If it's just dropping out like that you may need to replace the carb outright.
I've never seen one fall out, in fact I've never come across one that was easy to remove at all.
On the other hand I see 3 O'rings there, 1 is for the mixture screw, one is for the idle screw. I can't place the 3rd unless it's possibly for holding in the float needle seat... which I've never come across one done that way personally.
If it's just dropping out like that you may need to replace the carb outright.
I've never seen one fall out, in fact I've never come across one that was easy to remove at all.
On the other hand I see 3 O'rings there, 1 is for the mixture screw, one is for the idle screw. I can't place the 3rd unless it's possibly for holding in the float needle seat... which I've never come across one done that way personally.