bent Crankshaft

Status
Not open for further replies.

nlarr

New member
Messages
6
Reaction score
0
ok guys........i built a fun kart from a frame i found at a yard sale.... new drive line(motor,live axle,hubs,clutch,.....)the chain(#41) has 1/2" slack then i turn the wheels half turn and its tight.....it looks like the Crankshaft is bent .....as i said its new....i will return the motor for a new one tom.....any clues as to how i bent it? how hard it it to un-bend?
 

Rustydog2010

NZ Nutta :|
Messages
945
Reaction score
2
Location
New Zealand
how hard it it to un-bend?

Depends, how bent are we talking? Where about is it bent?

If we are talking thousands of an inch, it can be straightened by removing the crank and using a press. I have done this on Honda civic crank that was out of spec. Worked a treat.

If its new, I would defiantly look at returning it.
 

nlarr

New member
Messages
6
Reaction score
0
So it sounds like it wasnt something i did.....i just dont want it to happen
 
Status
Not open for further replies.
Top