Belt Clutches?

Status
Not open for further replies.

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
There are several factors involved, all boiling down to gear ratios. If you can get away with it, just stay with a belt drive. If you have to set up a jackshaft for compound reduction, change to chain. To wit- that's a 3" pulley. For a 6:1 ratio (for example) you'd need an 18" rear pulley- see the problem? At that point, you'd need a jackshaft.
 

jim454

New member
Messages
25
Reaction score
0
Does your 6H.P. Briggs have a threaded shaft?Usually the 1" shaft's use set screw's to hold the clutch on.
 
Status
Not open for further replies.
Top