Are these sprockets too unaligned?

[ThaKarter]

Hi,
I am doing a project for school. We mounted the engine, and attached the torque converter. This is how the sprocket and TC align. It is hard to get a good picture, but there is a little black one and behind it a big metal/gray one. It's clearly a tad off, but is this too much to the point that we should adjust the motor. It is really really annoying to bolt it down, so we are praying it is fine. Not sure if it matters, but the two sprockets are quit close to each other, like clearance between them is less than an inch.
Project is due tomorrow so any advice is appreciated haha.
Thanks!

 

[chancer]

My Gas Razor Buggy they were like 1" apart. No problems

 

[landuse]

They are probably close enough. If the chain starts falling off, then you will have to do something about it