Angled motor mount: Why?

Status
Not open for further replies.

Ken

New member
Messages
73
Reaction score
4
Location
West Michigan
There's a 15 degree clone mount clone on ebay right now. So I want to know what are the advantages of mounting the motor at a 15 degree angle?
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
As far as I know, it is usually for mounting engines that would be obstructed by the seat etc. More than 15 degrees and your engine does not get enough lubrication
 

Justin9

Member
Messages
116
Reaction score
3
Location
Quitman, GA
on the oval track go karts like I race, the old flathead engines needed to be angled to the gas tank would clear the RR tire... the 15 degree mount can also be used with a clone engine as well... I have seen some engines angled 30 degrees and they just ran a bit of extra oil to ensure the dipper could sling it around... I would think 30 degrees would be fine... I have seen a bike on the net somewhere that has the cylinder pointing straight up and there didn't seem to be any problems...
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I have seen a bike on the net somewhere that has the cylinder pointing straight up and there didn't seem to be any problems...

Straight up? 90*? Wow. Considering the natural angle of the gx cylinder is (iirc) 20*, that's a 70* incline...

To the op if it's not necessary to tilt the engine in your application, why bother?
 

Justin9

Member
Messages
116
Reaction score
3
Location
Quitman, GA
yeah, straight up at a 90... I stumbled onto it about two weeks ago googling for something... I can't remember, they even had a video of it running and it had a bully 2 disc clutch.... it was pretty neat...
 
Status
Not open for further replies.
Top