kartermicah
New member
What's the difference???
Yup...But ask any old kart racer and see what he says.
Who makes the the billet flywheel pictured there with that many fins? You sure thats billet?
seems they would save a ton of time and money by actually melting the aluminum rather than crushing it through an orifice. the stretching step seems like it would break the grain and make it weaker. i watched a show once where they mixed up some sort of epoxy and drew it down it a vacuum chamber to remove the air. the resulting product had very few if any air bubbles on the molded surface. when a tree is cut into lumber, they don't stretch it, they just send it through the saws, and voila, a billet. the force it takes to crush aluminum on that scale has to be tremendous. and it would seem a reason to keep toolers employed.
seems they would save a ton of time and money by actually melting the aluminum rather than crushing it through an orifice. .