Willisk2004
Williskart
So I’ve finally got the engine and all the parts I ordered and going to start assembling. But as an afterthought I wasn’t sure if I should do valve springs and rockers? Here is a list of things I’m doing!
Billet intake adapter to Mikuni carb. And air filter
Header
And removing the governor completely!
And the oil sensor! Already have torque converter setup on old engine and
I’m replacing the torque converter as old one is sieced to blown engine!
The kart has jack shaft already so should be fine on delivering torque to ground!
Should I do the springs and rockers?
Billet intake adapter to Mikuni carb. And air filter
Header
And removing the governor completely!
And the oil sensor! Already have torque converter setup on old engine and
I’m replacing the torque converter as old one is sieced to blown engine!
The kart has jack shaft already so should be fine on delivering torque to ground!
Should I do the springs and rockers?