7/8" crankshaft Clutch or Torque convertor for B&S 6.5hp Intek

[Sreams79]

Does anyone know if there is a clutch or Torq Convertor that fits 6.5 Intek motor with 7/8" shaft? Came off a parking lot blower. mounted on a push cart.

 

[Denny]

Never heard of one.

 

[Hellion]

Never heard of one either. Got the motor already but you're planning a kart build around it?

 

[panchothedog]

Get a different engine, or remove the crank and have it turned down to 3/4".

 

[anderkart]

Does anyone know if there is a clutch or Torq Convertor that fits 6.5 Intek motor with 7/8" shaft? Came off a parking lot blower. mounted on a push cart.

I found some info at this link showing the 6.5 Intek was available with a 6:1 gear reduction option that also included a 7/8" keyed output shaft:

https://www.briggsandstratton.com/content/dam/briggsandstratton/na/en_us/Files/FAQs/65%20hp%20VanguardHoriz.pdf

I'm wondering if you might have one of those?

Did you accurately measure the output shaft diameter with a Caliper, or just use a tape measure?

Posting pics of the output-shaft side, and telling us the model # of your engine might hook us up with important info needed to help you out.