Jalers
New member
Good day,
I have a Powerfist (Princess Auto) 6.5hp Honda clone engine. It is brand new last year.
I installed it into an atv with a Hilliard clutch.
It starts and runs fine. When I run full throttle, and let off the throttle, it stalls out. When I get to a stop, it starts right back up? This has been happening since brand new.
I have adjusted the idle, and no change.
i did remove the gas tank, and ran a gas line from the ATV gas tank into the carb. About 3' of hose. I also welded on a larger Diameter pipe to the exhaust to get the exhaust out the back of the ATV.
Any ideas?
Thanks,
Jay
I have a Powerfist (Princess Auto) 6.5hp Honda clone engine. It is brand new last year.
I installed it into an atv with a Hilliard clutch.
It starts and runs fine. When I run full throttle, and let off the throttle, it stalls out. When I get to a stop, it starts right back up? This has been happening since brand new.
I have adjusted the idle, and no change.
i did remove the gas tank, and ran a gas line from the ATV gas tank into the carb. About 3' of hose. I also welded on a larger Diameter pipe to the exhaust to get the exhaust out the back of the ATV.
Any ideas?
Thanks,
Jay