6.5 Harbor Freight engine stops running

Status
Not open for further replies.

redneckmechanic

New member
Messages
11
Reaction score
0
Location
Southport,NC
I just got the 6.5hp engine from HF last week and when I am running at full power and go down to idle when I turn it some times cuts off and I am not sure why. Is it the choke or spark plug ?
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
i would drain the harbor freight crap oil anyways, you know it may be fish oil? LOL. get some good oil. even stop&shop oil will be much better.

spark plug may need to be cleaned after break-in. a wire brush works fine. if you dont have this, sandpaper can even work. and a toothpick.

if it STILL has the problem, pop off the little cap on the idle speed screw, and tighten it just a little each time with a phillips head screwdriver until it is right.

hopefully after trying all these things it will be fixed. i heard someone on the PBP forum recently have a similar problem because the fuel-shutoff was not allowing in enough gas.
 

hoppy

New member
Messages
10
Reaction score
0
the oil sensor shut offs in those engines are garbage. diconect the thing and your problem will be solved. You should be checking your oil regularly anyway so not having it on there should not be an issue. When you turn or even go up/down hills this sensor will give you issues. remove it and be done.
 

redneckmechanic

New member
Messages
11
Reaction score
0
Location
Southport,NC
Well I cut the wire and it still cuts off if I am going around a turn and take my foot off the gas and then go to full power it will cut off and vice versa
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
how well does it idle? turn in this screw to make it idle higher.

yours might have a cover on it. just pull it off.

 

redneckmechanic

New member
Messages
11
Reaction score
0
Location
Southport,NC
i did that and it is all the way down but I think it has to do with the gas line or choke because I have to run it at half choke for like 10min before I can take it to full choke other wise it will cut off
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
Is it running lean and then when you give it more air by taking off the choke or backing off the pedal too fast the amount of gas taken in isn't enough or drops so much that it cuts off?
 
Status
Not open for further replies.
Top