6:1 Reduction?

Status
Not open for further replies.

Pellethuntr2

Machinist
Messages
224
Reaction score
0
Location
NY
Question for all you experienced guys.. I have a 7hp Briggs with one of those bolt on 6:1 gear reductions.. My question does the gear reducer take the place of using a large rear sprocket for more low end torque? I plan on using a standard 12 tooth clutch, so does that mean I should get a 12 tooth rear sprocket to keep the 6:1 ratio? The rear tire on my bike is 26 inches and a 6:1 ratio seems to be a good mix of speed and low end.. thanks for any help
 

fowler

New member
Messages
5,463
Reaction score
18
Location
Bullsbrook West Aus
u cant use a clutch as the revs are 6x slower so the clutch wont engage

most of these reduction boxes have clutches build in

and yes the box will replace a large rear sprocket but u may still need a small reduction
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
That works out to be a top speed of 50mph approx. with the engine at 4000 rpm. I would aim for about 35 max, depending on terrain.
If the reduction box has no clutch, you could use a belt tensioner setup or sell the reduction box and buy a clutch and sprocket.
Rob
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
With that big tire, you may need further reduction. First, determine whether it has a built-in clutch. This should be as easy as trying to spint the output shaft with the engine off. If turning the shaft results in the engine turning, it either has no clutch or the clutch is seized. If it turns freely or with little effort, then it's got a clutch.

Then work out the math on an appropriate gear ratio and select sprocket sized based around that. For the sake of leverage, I would not suggest the smallest sprockets useable, especially on the axle. For example (supposing it does have a clutch). Let's say you need further reduction and the numbers work out to 10T on the engine and 15T on the axle. I would then recommend doubling that- 20T on the engine and 30T on the axle. Same ratio, just bigger sprockets.
 

Pellethuntr2

Machinist
Messages
224
Reaction score
0
Location
NY
Thanks a lot guys I knew I could count on you.. I have never seen a gear reduction till now so bare with the newb questions lol.. I can't believe it never occurred to me that there was a clutch built into it.. I will have to have a good look tomorrow and see if it's in good shape.. That just saved $40+ lol
 
Status
Not open for further replies.
Top