5hp briggs problems

Status
Not open for further replies.

Nissinator1996

New member
Messages
54
Reaction score
0
a while back i had my 5hp running perfectly fine but it had an oil leak...so a couple of days ago i fixed the oil leak and went to start it and it wouldnt start...i took apart carb and cleaned it nothing was plugged and still looking in pretty good condition...although i still cant it get to start....if i spray starting fluid in through the airintake it acts like it wants to start and sputters...so any idea
 

exenos

Project Nut
Messages
1,217
Reaction score
0
Location
Ontario, Canada
Ok, I was wondering if the leak was from crack in the block. If it was from the block i would have suggested that there was a crack somewhere in the bore that reduced the compression to a point that it wouldn't run with gas.

EDIT: Just had a thought. Any chance that you messed with the timing gear by accident?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Is there any slack in the spark plug wire? I had an incident once where the insulation was degraded, and every time I turned left, the wire swung over and grounded out against the block, killing the spark.

Check the float level for correct setting, and whether it's properly floating.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
What exactly did you touch or change when fixing this leak? What did you remove?

Why I am asking, is that we can maybe see if there was something you did that could cause your engine not to start
 

Nissinator1996

New member
Messages
54
Reaction score
0
i didnt do anything but pull off the side cover to fix leak...i stayed up last night and tore down the entire engine and built it back up making sure everything is perfect...made sure timing was okay...i used some rtv silicone gasket maker(ive ran engines using just fine so i know it works)well i let it sit overnight so silicone would dry...went out their to start it up and does the same exact thing...ive been redoing engines for a while now and this particular engine ive tore down and rebuild like 20 times and every time it starts right up...so please help ive only got a couple of hours to get this running...
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
a while back i had my 5hp running perfectly fine but it had an oil leak...so a couple of days ago i fixed the oil leak and went to start it and it wouldnt start...i took apart carb and cleaned it nothing was plugged and still looking in pretty good condition...although i still cant it get to start....if i spray starting fluid in through the airintake it acts like it wants to start and sputters...so any idea

If it wants to start with some starting fluid, then all I can hazzard a guess at is that it has to do with the fuel system in some way. Go through it all thoroughly again. Is your carb really clean?
 

Nissinator1996

New member
Messages
54
Reaction score
0
yes ive had 3 carbs all the same like i said it was running about a month or two ago so i tried using the same carb and everything and wouldnt run so i tried other 2 still wouldnt run so i used some carb cleaner and cleaned all of them really good and let them all sit overnight put each one back on this morning and still dont start...also when i take carb off tank u can tell the diaprahm is working cuz the gas is in the jet bowl type thing...and i kno this carb work i used it all the time untill about month ago
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
I'm going to give you a step-by-step process of a test you should run to make sure its not the carb. Take your spark plug off, dump a teaspoon of gas into the cylinder, put the plug back in, try to start her up. If she fires up, it is either a fuel problem or intake problem. If she doesn't fire, it is an probably an internal issue. Meaning, rings might be shot, timing isoff, etc. I might look at replacing the spark plu also and test your ignition coil.
 
Status
Not open for further replies.
Top