5-h.p. b&s head work

[I like karts]

Awesome. Can't wait

 

[kibble]

Ooh, I would like to see that!

 

[enel1221]

fixed the leak hopefully, someone put the fuel pump cover on upside down... so hopefully the diaphram isn't messed up. too late to take video now i'll take one in the morning.

 

[enel1221]

Posted short video on youtube of the dual carb, no sound for some reason, trying to figure that out.

http://www.youtube.com/watch?v=rfa9ElfVP-s

 

[I like karts]

That's freakin' awesome!

 

[ironman]

your the man that has to be one of the coolest thing hey take a picture of it its hard to see in the video and i could hear the sound sounded great .good job on the customize.

 

[newrider3]

Posted short video on youtube of the dual carb, no sound for some reason, trying to figure that out.

http://www.youtube.com/watch?v=rfa9ElfVP-s

Did you put that alumnium flywheel on it? If so, get a steel flywheel. Those cast alumnium flywheels will kill you when they explode, and they do so not far over governed rpm. That dual carb set up looks awesome, great job!

 

[oscaryu1]

How'd you make it? (The dual carburetor manifold thing)

 

[enel1221]

first of all i have cast iron flywheel on right now, did have a 3.5hp aluminum flywheel that i was debating whether to put on or not. to make the manifold i used 1/8" thick piping same diameter as the intake on engine. cut at a random angle and mig welded together, then the flanges that go on the engine and carbs i drilled on a mill. Then brazed the flanges on the pipe (brazed becuase i did this for school project and needed to braze something) those are 2 tecumseh chainsaw carbs that i had laying around. also sorry bout the sound quality sucks cause all i have to take video with is my phone

I'll take another video in about a week when i ahve throttle hooked up to pedal and working