420cc predator engine mount hardware

Status
Not open for further replies.

scatteredsun

Member
Messages
107
Reaction score
0
Location
Seattle
I need to get hardware to mount my engine. I went through the manual and didn't see any sizes. What size bolts? Should I just get regular nylock nuts? I see some kits with rubber grommets, what size? Locking washers needed?

I don't want to buy a kit and wait for shipping.
 

Kentucky Boy

Member
Messages
611
Reaction score
49
Location
Bowling Green, KY
Look at the holes and go to the hardware store : Ace, Lowes, Tractor Supply, Home Depot...they should have plenty of what you're needing. Long bolt, washer, lock washer and a nyloc nut x 4.
 

mckutzy

Well-known member
Messages
8,353
Reaction score
113
Location
bc, canada
Off hand I think 5/16 will do... Nylock nuts would help... But nuts/lock washers will be fine. Could double with blue locktite(so you can take it apart later)
 
Messages
357
Reaction score
7
Location
Dallas, TX
If I remember correctly I used 5/16x18 coarse thread with nylon lock nuts. If the engine is not raised at all a 1.5in works just fine, if raised just add to the 1.5 in length depending on how high the engine is raised.

--Dan
 

scatteredsun

Member
Messages
107
Reaction score
0
Location
Seattle
Thanks! Blue locktite is a good idea. I'll get 5/16x18 1.5" if they don't reach, I'll just get longer ones :) bolts are cheap.

thanks all!
 
Status
Not open for further replies.
Top