40 series mounting...

Status
Not open for further replies.

DJEEPER

New member
Messages
205
Reaction score
1
OK, so my 18HP engine just received the torque converter i bought.

HOWEVER... the engine shaft does not run the full length of the driver. Is this ok to have the shaft 3/4 of the way into the driver? What should I do with the rest of it...just buy a bolt that threads into the shaft to pull it all tight?

with the driver mounted in the normal direction, it rubs on part of the engine where a pump or something would mount.

Option 1: Mount driver beckwards. Any issues with this?

Option 2: grind down points of contact on the engine.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
You cannot mount the driver backwards. You will have to install a spacer behind the driver to keep it from interfering with anything.

As far as the crank not protruding through- Cut a section of pipe, thick wall tube, or similar to fit inside the driver bore to take up the extra gap between the end of the crank and the outside edge of the driver, and use a long enough bolt to engage 3/4" (or more) of the crank threads.

Got a pic of driver interfering with block?

Actually, there IS one other option- you can get a reversed spring for the driven (but I don't know who carries it. If you do install that reversed spring in the driven, you can then mount BOTH units inboard. Probably too much of a PITA, though. Just remember, both driver and driven must face the same way, and DRIVEN is directional.
 

DJEEPER

New member
Messages
205
Reaction score
1
Sounds good. I will do that. Will get some work done on it this weekend... been a busy week haha
 
Status
Not open for further replies.
Top