4 different exhausts which is better ????

Status
Not open for further replies.

kartmonster13

New member
Messages
82
Reaction score
0
ok guys i have different exhausts i have a staight plumbing pipe on right now but its only about 9.5 inches and i have these other three i have a curly one on my racing go cart with the trx200 motor on it and it sounds loud and nasty top one is a old kx125 muffler and the straight pipe with tip came with this cart just not on it
 

Attachments

  • 100_4963.jpg
    100_4963.jpg
    117.7 KB · Views: 14
  • 100_4964.jpg
    100_4964.jpg
    106.8 KB · Views: 6

kartmonster13

New member
Messages
82
Reaction score
0
its a 5hp briggs fun power it already has a 9.5 inch straight plumbing pipe on it
 

Attachments

  • 100_4874.jpg
    100_4874.jpg
    235.7 KB · Views: 18
  • 100_4880.jpg
    100_4880.jpg
    245.1 KB · Views: 8

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Honestly, I don't think any of those would be suitably because they'll hang off the back by about 2 feet. Stick with what you have or, if you really want to change it, go custom
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
I'd use that 3-stage header with the RLV race muffler in the center of your pic, the pipe with the loop is much larger diamiter and would be better suited for a full race engine.
 

kartmonster13

New member
Messages
82
Reaction score
0
will it give it more power? or maybe run better? ive seen people talking about it needs to be around 14 inches or so
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
You might notice a little difference over your old pipe with a stock engine. Guys that build racekart engines for a living use all kinds of different length/design headers trying to squeeze an extra 1/10hp dyno readings at specific rpm ranges, but a 14" length is probably a pretty good guess when building a simple homemade pipe.
 

jamyers

Well-known member
Messages
1,444
Reaction score
49
Location
Buffalo Gap, TX
If you use anything much longer than stock, you'll REALLY want to brace it. Having it strip itself out of the block ain't fun.

Cheap / Easy braces can be made from something like metal conduit and a hose clamp, like I did here. Use a BFH to shape the conduit, drill and bolt one end, clamp the other. Even then, after running it awhile I needed to brace it for sideways movement, so I added another brace going down to the right-hand side frame rail just aft of the axle bearing.

 
Status
Not open for further replies.
Top