Rat
Well-known member
So I'm working on a 301cc Hemi Predator powered kart.
The engine refused to start at all, after noting the chain was too tight and removing it it starts first pull but only runs with 1/4 which floods it when you pop the throttle.
The owner said "Let's get stupid then" after filling him in on the details of what that means.
The plan is to stick a Keihin PWK on it, I'm figuring a 28mm and gut the gov out of it.
What I need to know is what weight the stock valve springs are, and if I'm going to need to put heavier in as well as if there are any billet parts I should advocate for.
Im probably going to push for a Dover Coil, and I've already found BMI has the ARC flywheel and Rod (+0.20)
I'm figuring conrod and flywheel for sure but it's not getting a cam or any major work, maybe a little port cleaning though
The engine refused to start at all, after noting the chain was too tight and removing it it starts first pull but only runs with 1/4 which floods it when you pop the throttle.
The owner said "Let's get stupid then" after filling him in on the details of what that means.
The plan is to stick a Keihin PWK on it, I'm figuring a 28mm and gut the gov out of it.
What I need to know is what weight the stock valve springs are, and if I'm going to need to put heavier in as well as if there are any billet parts I should advocate for.
Im probably going to push for a Dover Coil, and I've already found BMI has the ARC flywheel and Rod (+0.20)
I'm figuring conrod and flywheel for sure but it's not getting a cam or any major work, maybe a little port cleaning though
Last edited: