212cc predator throttle

Status
Not open for further replies.

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
i got a harbor freight engine and the throttle is meant to be set in one position. im wondering how would i get it set for spring return without voiding the warranty on it?

without extra springs on it it will stick. even with the nut thats holding down the arm almost off
 

Jcotz

...wasn't there
Messages
374
Reaction score
1
Location
NY
Is anything in there gumming it up somehow? I assume this is a pretty new engine though...
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
I've always heard people remove the thrust washer under the main linkage pivot point and add a small return spring to the muffler's heat shield.
 

gvfc2

wishing i was living
Messages
943
Reaction score
4
Location
Tacoma,wa
well i got it. had some money to go buy a spring from the local home depot. a 9lb spring screwed it in to one of the cable clamps then to the cable sheath clamp. no that is not my voice. just some random youtube vid

 
Last edited:
Status
Not open for further replies.
Top