212 Hemi Cast Valve Cover Breather?

[gokarttimmy]

Hello-I just purchased a brand new 212 Hemi Predator. I would like to install a top plate kit with a fuel pump. Is there any issue with drilling a hole in the cast valve cover for the pulse fitting? I know the older ones had a steel cover that was easy to install one in. How about drilling a fitting into the intake manifold?Thanks for any info.

 

[Kart Simpson]

I just did my Predator Hemi and was also weary of drilling the cast aluminum valve cover so I bought one if these for the pulse and it works great.

http://www.ebay.com/itm/GX200-Clone...er-with-Fuel-Pump-Pulse-fitting-/351121524761

And I did this with the breather tube

 

[gokarttimmy]

Yeah, that looked like a logical solution-so I bought one too!!! Thanks.

 

[2SlickNick]

I am probably going to need a fuel pump too.

Can't I just run the pulse line through the breather hole on valve cover?

 

[commonrail]

I read the thread incorrect..

Edited.

 

[Scout]

I drilled and tapped my cast cover. Then I drilled and tapped the port on the bottom of the stock tank to take an appropriately sized hose barb.