196cc generac clone honda motor

Status
Not open for further replies.

drwood

New member
Messages
12
Reaction score
0
Ok I've got a generac 196cc clone that just isn't running right. If my boy rights the kart it'll ride all day fine. But once you really step on the gas get moving it dies out in a turn or once u normally slow down it just cuts off. I've made idle adjustments slightly checked the carb it's a brand new motor so carb was clean. Upgraded plug to ngk even tried a e3 nothing. Just curious if ya'll ever had this problem with the clones. Don't know much about em.
 

drwood

New member
Messages
12
Reaction score
0
Ok I checked for oil sensor didn't see one. Just two wires coming off cut off one green one black and travels to a black box. In thinking it doesn't have one by watching video on other thread. Any other ideas of what could cause this? Thanks or could the oil sensor be under that black box
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Look for a wire coming directly out of the engine block- it will look like it passes thru a bolt. It will be about halfway up from the bottom, usually on the forward side of the engine. Post a pic of your wiring.
 

drwood

New member
Messages
12
Reaction score
0
Yeah I had thought it was but it still cuts off while disconnected. It doesn't seem to cut off as much though.
 
Status
Not open for further replies.
Top